Newest Products

1/4" BSP, 125mm. These can safely be cut with wire snips to any shorter length, so be sure to keep your old one so you can match the shape and leng...

PTFE plastic with four embedded magnets.   Cross-references: Part number Manufacturer 6.9.23.25G Gicar 5102751 LF

1/4" BSP, 120mm.   Cross-references: Part number Manufacturer C199900214 ECM 3341017 LF C199900214 Profitec

1/4" BSP, 90mm.  OEM The auto-fill probes on some equipment are bent prior to installing into the side of the boiler, so be sure to keep your old o...

1/4" BSP, 100mm. The auto-fill probes on some equipment are bent prior to installing into the side of the boiler, so be sure to keep your old one s...

1/4" BSP, 80mm. The auto-fill probes on some equipment are bent prior to installing into the side of the boiler, so be sure to keep your old one so...

NSF certified low pressure flowmeter with 7mm barbed outlet fitting.   Cross-references:  Part number Manufacturer 9.0.99.28G Gicar 5032820 L...

Connector for Gicar flowmeters. The female voltage terminal slots are spaced at 9.5 mm from left to right and the center ground wire terminal slot ...

Fits all Gicar flowmeter bodies, though check your lid: the pin configuration may be different.  It is recommended that you also replace the oring.

1/8" BSP, 115mm.   Cross-references: Part number Manufacturer CRP.24  Ascaso 400.020  Fast Ricambi 9.0.83.98G  Gicar 1341802  LF 342000...

1/4" BSP, 140mm. The auto-fill probes on Simonelli equipment are bent prior to installing into the side of the boiler, so be sure to keep your old ...

Does not include o-ring. A good flowmeter lid should read 1.8- 2.2k ohms with a voltage meter.

PTFE plastic with two embedded magnets.   Cross-references: Part number Manufacturer 13505 Astoria 15505 Astoria 4831091782 Faema 6.9.23...